2009 Ford Ranger Change Dash Lights

From WikituneUp - The Free Service Manual
Jump to: navigation, search

The dash lights in a Ford Ranger are located in the instrument cluster. The bulbs used in the panel provide plenty of light to see the gauges and also light up the dash for visibility. The bulbs can be purchased at any automotive-parts store. Replacing the bulbs only takes a few minutes, but first you must remove the instrument panel to gain access to them.

Tools Used[edit]

Tools
Socket wrench
Socket set
Phillips-head screwdriver
Sylvania bulb part number 161

Change Dash Lights[edit]

  • Open the door for more room to access the instrument cluster. Lower the steering wheel for additional room.
  • Unscrew the bolts around the bezel that surrounds the instrument panel. There will be three bolts to unscrew. Use a socket wrench. Slide the bezel out and place it to the side.
  • Loosen and remove the screws around the instrument panel. Pull the instrument panel out from the dash.
  • Trace the wiring to the tabs that are screwed into the back of the panel. Unscrew the tab counterclockwise. Pull the tab straight out to expose the bulbs.
  • Pull the bulb straight out by hand. Replace with the new bulb. Push it straight in until it stops.
  • Replace the remaining three bulbs the same way. Tighten the panel to the dash with a socket wrench. Tighten the bezel back to the dash.

Tips & Warnings[edit]

  • The bulb to use for the dash is Sylvania part number 161.[[Category:Ford Ranger

Its a 2 hour job and you need a 7mm and an 8mm socket also. Watch the videos on youtube. The bulb is not a 161 or a 194. Much smaller, there are 10 total. Only from Ford I think.